Filter
Top Products
311
Operation
Engine compartment
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
Turn on ignition
to see engine oil level!
̈ Switch on the ignition (୴ page 36).
If you see the message:
Observe waiting time
̈ If engine is at operating temperature,
wait five minutes before repeating
check procedure.
̈ If engine is not at operating
temperature yet, wait 30 minutes
before repeating check procedure.
If you see the message:
Engine oil level
Not when engine on!
̈ Turn off the engine.
̈ If the engine is at operating
temperature, wait five minutes before
checking oil.
̈ If the engine is not at operating
temperature yet, you must wait
30 minutes before checking oil.
If there is excess engine oil with the engine
at operating temperature, the following
message will appear:
Engine oil level
Reduce oil level
!
̈ Have excess oil siphoned or drained
off. Contact an authorized
Mercedes-Benz Center.
More information on messages in the
display concerning engine oil can be found
in the “Practical hints” section
(
୴ page 379).
!
Excess oil must be siphoned or drained
off. It could cause damage to the
engine and catalytic converter not
covered by the Mercedes-Benz Limited
Warranty.