Filter
Top Products
155
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
button æ or ç to the
Lighting
submenu.
̈ Press button j or k repeatedly
until the message
Lamp circuit
headlamp
appears in the multifunction
display.
The selection marker is on the current
setting.
̈ Press æ or ç to select manual
operation (
manual
) or daytime running
lamp mode (
constant
) activated.
With daytime running lamp mode activated
and the exterior lamp switch in
position M or U the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Side marker lamps
For more information on the daytime run-
ning lamp mode, see “Lighting”
(
୴ page 124).
i
This function is not available in
countries where the daytime running
lamp mode is mandatory and therefore
in a constant mode.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting
submenu to factory settings
(
୴ page 147) while driving will not
deactivate the daytime running lamp
mode.
The following message appears in the
multifunction display:
Lighting – Cannot be completely
reset to factory settings while
driving
.