Filter
Top Products
95
Controls in detail
Seats
Removing and installing front seat
head restraints
For more information on head restraint ad-
justment, see the “Getting started” section
(
୴ page 36).
Front seat head restraints
1 Switch
Removing front seat head restraint
̈ Press switch 1 upwards and hold until
the head restraint is fully extended.
̈ Pull head restraint out.
Installing front seat head restraint
̈ Press switch 1 upwards and hold for
about five seconds.
̈ Press the head restraint down until it
engages.
̈ Adjust head restraint to the desired po-
sition.
Synchronizing head restraints and seat
adjustment fore and aft for front seats
If the power supply was interrupted (bat-
tery disconnected or discharged), the head
restraints and the seat adjustment fore
and aft are no longer adjusted automatical-
ly.
The head restraints and the seat adjust-
ment fore and aft must be resynchronized:
̈ Turn SmartKey in starter switch to
position 2.
̈ Move the seat completely forward
(
୴ page 35) and the head restraint fully
down (
୴ page 36) and hold the switch-
es for approximately one second.
Warning! G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that the head re-
straint supports the back of the head at eye
level. This will reduce the potential for injury
to the head and neck in the event of an ac-
cident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
Do not interchange head restraints from
front and rear seat.
i
Tilt the seat backrest rearward for eas-
ier removal and installation of the head
restraints.