Filter
Top Products
310
Practical hints
Flat tire
Lowering the vehicle
̈ Using the pump lever, open the lower-
ing screw on the jack approximately
one turn (
୴ page 308).
The vehicle is resting fully on its own
weight.
̈ Remove the jack.
After use, disassemble pump handle
(
୴ page 308) and store jack in the des-
ignated storage compartment
(
୴ page 284).
1 - 5 Wheel bolts
̈ Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to 5), until all bolts are tight.
Observe a tightening torque of 97 lb-ft
(130 Nm).
̈ Press the jack piston in again and close
the lowering screw. Store the jack
(
୴ page 284) and the other vehicle
tools (
୴ page 283).
̈ After changing the wheel, secure the
damaged wheel on the spare wheel
mounting bracket (
୴ page 286). Make
sure the wheel cannot come loose.
̈ Check the tire inflation pressure and
correct it if necessary.
A table with the tire pressure values for
your vehicle is located on the fuel filler
flap.
Warning! G
Have the tightening torque checked after
changing a wheel as soon as possible. The
wheels could come loose if they are not
tightened to a torque of 97 lb-ft (130 Nm).