Lowrance electronic 5150C GPS Receiver User Manual


 
101
Update Trail Option
This menu lets you change the way the trail updates occur.
WARNING:
If you uncheck the Update Trail option, automatic trail
creation and recording will be turned off. You must turn
it back on to record trails. The default setting is on.
From the Trails Menu, press to
OPTIONS|ENT. With UPDATE ACTIVE TRAIL
highlighted, press
ENT to check it (turn on) and uncheck it (turn off).
The options are automatic, time, or distance. When it's in the default
automatic mode, the unit doesn't update the plot trail while you're
traveling in a straight line. Once you deviate from a straight line, the
unit "drops" a plot point (trail waypoint) onto the trail. This conserves
plot trail points. If a plot trail uses all of the available points allotted to
it, the beginning points are taken away and placed at the end of the trail.
From the Trails Menu, press to
OPTIONS|ENT| to UPDATE CRITERIA.
Press or to select criteria type|
ENT.
You can update a trail by time, with a range from 1 second to 9999 sec-
onds; the default is 3 seconds. You can update by distance, with a range
from 0.01 mile/nm/km to 9.99 mile/nm/km; the default is 0.10 mi.
With one of the Update Criteria selected, use the cursor arrows to high-
light either the
UPDATE RATE or UPDATE DISTANCE data entry boxes and
press
ENT. Press or to change the first character, then press to
the next character and repeat until the entry is correct. Press
EXIT to
return to the Trail Options Menu.
Update Time Rate setting (left). Update Distance setting (right).