Filter
Top Products
40
The Transfer My Data submenu asks if you want to save data to the
MMC or load data from the MMC into the iFINDER's memory.
2. If no MMC is present, a message will appear letting you know there
is no card in the iFINDER. You must insert a card to activate the Load
or Save commands.
To transfer data from the iFINDER to the MMC, press
ENT.
To transfer data from the MMC to iFINDER, press → to
LOAD|ENT.
3. Saving: To accept the default name Data for the GPS Data File,
press ↓ to
SAVE|ENT. If you wish to rename the file (as in the example
below), press
ENT to activate the selection box. Press ↑ or ↓ to change
the first character, then press → to the next character and repeat until
the name is correct. Then, press
ENT|↓ to SAVE|ENT.
The unit will display a completion message when the data transfer is
finished. To return to the main page display, press
EXIT repeatedly.
These figures (from left to right) show the menu sequence for naming
and saving a GPS Data File from an MMC to the iFINDER's memory.
4. Loading: There may be more than one GPS Data File (*.USR) on the
card. To select a file, press
ENT to activate the selection box, use ↓ or ↑
to highlight the file, then press
ENT to accept the selection. Next, press
↓ to
LOAD|ENT. The unit will display a completion message when the
data transfer is finished. To return to the main page display, press
EXIT|EXIT.