Filter
Top Products
12
Be sure to check the suction mount for adequate adhe-
sion each time you use the unit, and reinstall it if neces-
sary. This is a portable mounting device, and the normal
heating and cooling cycle of a car's interior will eventu-
ally loosen the seal. A loose suction cup could allow the
unit to fall or come loose during a turn.
Assembly
Use a Phillips screwdriver to assemble the mount components provided
with your unit. A plastic cradle, movable arm and plastic ball base con-
nect to a suction cup to attach the unit to your vehicle's windshield.
Assembled suction cup mount for the iWAY 100m.
Installing the RAM Suction Mount
The suction cup mount is designed to secure the GPS to a windshield or
other smooth surface. The mounting surface should be free of dirt and oil.
Remove the socket arm from the base and make sure the base locking
lever is in the off position. (See the following figure.) Use both hands and
press down hard on the mounting surface. While maintaining pressure,
turn the lock lever to "on" (this will require some force). Attach the plastic
cradle to the socket arm, then attach the arm (with cradle) to the base.