21
the desired number shows. Continue until the time
shown in the display is correct, then press the
ENT key.
To start the timer, press the MENU key, then move
the black box to the “Dn Tmr Off On” label. Press
the right arrow key to start the timer. The timer
continues counting until you stop it. If you turn
the up timer’s alarm on (press the right arrow key
when the black box is on the (Up ALM...Off/On
label), it will flash a message when it reaches the
time you entered in the up timer set menu. Press
the EXIT key to erase the message.
You can reset either alarm to the time you originally set by pressing the
MENU key, then moving the black box to either the “Up Tmr Reset” or
“DN Tmr Reset” label, then press the right arrow key.
REPROGRAM BOXES
The digital boxes on the PLOT-2 and both NAV screens can be repro-
grammed. The changes you make to the screen will remain in memory,
even if all power is removed from the unit. You can, however, return to the
factory settings from the “Preset Groups” item in the “System Setup” menu.
To customize a screen, first switch to the screen that you want to custom-
ize. In this example, we’ll change Plot-2. Next, press the MENU key, then
highlight the “Reprgr Boxes” menu. Press the right arrow key. The screen
shown below center appears.
This is the plot-2 edit screen. The “BRG” box near the left corner flashes,