Filter
Top Products
29
A. Start to Track
Fig. 5-3-2 Fig. 5-3-3 Fig. 5-3-4
(i) Move marked field to Off/Fill/Wrap, press “
”
(ii) Select Fill or Wrap and press “ ”.
(iii) Press “
”, select Recording Mode as Fig. 5-3-2 and press “ ” as Fig. 5-3-3 to set
your recording mode. There are two parameters-- time and distance. You may set either
one or both as recording criteria.
(a) Distance
Move the marked field to Dist Interval and press “ ”. Interval options include 20,
50, 100, 200, 500m, 1, 2 and 5km. You may select one or leave the field “-----“ to
ignore the parameter and press “ ”.
(b) Time
Move the marked field to Time Interval and press “ ”. Interval options includes
1, 2, 5, 10, 20, 30 seconds, 1, 2, 5 and 10 minutes. You may also select one or leave
the field “-----“ to ignore the parameter and press “ ”.
(iv) Move the marked field to “ˇ” as Fig. 5-3-3 and press “ ”.
(v) Move the marked field to “ˇ” as Fig. 5-3-1 and press “ ”.
(vi) As soon as the Explorer identifies your position, it starts recording track logs. It sets
a track log when meeting either parameter. There will be a dotted line between two track
logs if they are far from each other.
(vii) 2,500 track logs are maximum for each tracking log. But the dots in the dotted line
mentioned above (vi) are not included in the 2,500 track logs.
Important: If you set recording mode FILL, when the
Explorer records up to 2,500 points, the
screen will show:
Tracking Full
Save or Clear