Filter
Top Products
24
Using the Project feature, the eTrex can create a
waypoint at a specifi ed distance and bearing using an
existing waypoint as a reference. You can also change the
name, symbol and elevation on this page.
Projecting a waypoint:
1. Select a waypoint from the list on the ‘WAYPOINTS’
Page and press ENTER. The ‘REVIEW WAYPOINT’
Page is displayed.
2. Using the UP or DOWN Button, highlight the
‘PROJECT’ fi eld and press ENTER. The ‘PROJECT
WAYPOINT’ Page will appear and a numeric name
will be assigned to the new waypoint.
3. The distance fi eld will be highlighted by default.
Press ENTER to display the ‘EDIT NUMBER’ Page.
4. On the ‘EDIT NUMBER’ Page, pressing the DOWN
Button will move the highlight to the next number
in the fi eld. With the desired digit selected, press
ENTER to activate the drop-down number list.
5. Using the UP or DOWN Button, select the correct
number and press ENTER. When all numbers are
entered correctly, highlight ‘OK’ and press ENTER.
6. Using the DOWN Button, hightlight the bearing
fi eld and press ENTER to display the ‘EDIT ANGLE’
Page.
7. On the ‘EDIT ANGLE’ Page, pressing the DOWN
Button will move the highlight to the next number
in the fi eld. With the desired digit selected, press
ENTER to activate the drop-down number list.
8. Using the UP or DOWN Button, select the correct
number and press ENTER. When all numbers are
entered correctly, highlight ‘OK’ and press ENTER.
9. The name, symbol and elevation can be changed
on this page as well. When all changes have been
made, highlight ‘OK’ and press ENTER to save the
waypoint. Highlight ‘GOTO’ and press ENTER to
save the waypoint and begin direct navigation to
the point.
Reference
Review
Waypoint Page
The ‘PROJECT
WAYPOINT’ Page
The ‘EDIT NUMBER’
Page
etrex manual.indd 10/12/00, 11:17 AM24