Filter
Top Products
C-8
· Connect the antenna or antenna cable. No other electrical connections
are required; all power and data connections are made through the 6-
pin connector installed in the universal mount.
To remove the GPS 50 from the universal mount...
· Disconnect the antenna or antenna cable.
· Apply enough force to the release tab to allow the unit to pass as shown
above.
· Pull the bottom of the GPS 50 out, then rotate the top downward and
out.
To adjust the universal mount angle...
· Loosen the mount by turning the lever counter-clockwise.
· Rotate and/or tilt the unit to the desired position.
· Tighten the lever.