Filter
Top Products
A-2
MEM BATT - The battery that sustains user memory is low and should be
replaced by an authorized GARMIN service center as soon as possible.
Failure to do so may result in loss of stored data, including all waypoints and
routes.
MEM FULL - The waypoint memory is full. You should delete unused
waypoints to make room for new waypoints.
NO EMP RT - There are no empty routes available into which another route
may be copied. The GPS 50 will not allow you to copy a route to a non-empty
route.
POOR CVRG - The GPS 50 cannot acquire sufficient satellites necessary
to provide navigation.
RCVR FAIL - The GPS 50 has detected a failure in the receiver hardware.
If the message persists, the GPS 50 is unusable and should be taken to an
authorized GARMIN service center.
RE-INIT - The GPS 50 is unable to compute a position. Initialize the position
on the Position Page to within 1000 nautical miles of your actual position.
ROM FAILD - The GPS 50 has detected a failure in its permanent memory.
If this message occurs, the unit is unusable and should be taken to an
authorized GARMIN service center.
ROUTE WPT - An attempt has been made to delete a waypoint which is a
member of one or more routes. You must remove the waypoint from all
routes before the waypoint can be deleted.
RTE FULL - An attempt has been made to add more than nine waypoints to
a route. The GPS 50 will not allow more than nine waypoints per route.
SRCH SKY - The GPS 50 is in search-the-sky mode. Allow the unit to
complete its data collection before turning it off.
TIMER EXP - The count down timer has expired.