Filter
Top Products
C-4
data interface. The unit can provide data for up to three NMEA “listeners”
simultaneously. Refer to installation instructions of these devices for further
information.
To connect the GPS 50 to an NMEA electronic device...
· Connect the BROWN harness lead to the NMEA “A” line of a two-wire,
shielded cable.
· Connect the BLACK harness lead to the NMEA “B” line of the shielded
cable.
· Connect the BLACK harness lead to the shield of the shielded cable.
(The opposite end of the shield should not be grounded.)
C.3 UNIVERSAL MOUNT INSTALLATION
The GPS 50 is equipped with a universal mount for fixed installations. The
universal mount may be installed above the dash or attached to a surface as
shown below.
Although your GPS 50 is designed to withstand the marine environment, it
is recommended that it be mounted in a location which provides protection
from sun and spray. Before permanent mounting, you may wish to apply
power to the unit and look at the display in the desired mounting location to
ensure you have the desired viewing angle.