Filter
Top Products
To change the display contrast settings:
1. Press and hold
M
and rotate
O
to show the ‘Display’ page.
2. Press
C
twice and use
K
to select ‘auto’ or ‘manual’ control.
3. Press
E
.
4. If ‘manual’ is selected, use
K
to set the display constrast level. (If ‘auto’ is selected you may
also change the offset level to your preference.)
5. Press
C
to complete.
The ‘mode’ selection allows you to display on-screen characters as black on a light
green background (positive) or light green on a black background (negative). With the
‘auto’ setting the photocell selects the best mode for day or night viewing.
To change the display mode settings:
1. Press and hold
M
, and rotate
O
to show the ‘Display’ settings page.
2. Press
C
twice and use
O
to highlight the ‘mode’ field.
3. Rotate
K
to select ‘pstv’, ‘ngtv’ or ‘auto’.
4. If ‘auto’ is selected, rotate
O
to highlight the threshold level, and use
K
to select the level
at which the display will switch from positive to negative for night time use. (Note: Some
experimentation may be necessary to obtain the desired response level.)
The backlight intensity settings control the backlighting level and allow for automatic
adjustment using the built-in photocell or manual adjustment.
81
Setting the display mode to ‘negative’ will display
on-screen characters as light green on a black
background. This setting is suitable for night time
operation.
The display contrast may be set to automatically
adjust to varying lighting conditions, using the
built-in photocell.
SECTION
6
UNIT SETTINGS
Display Settings
250xl manual 2 7/17/98 1:33 PM Page 81