Filter
Top Products
The scheduler function will display reminder messages (such as ‘Change oil’, ‘Switch
fuel tanks’, ‘Overhaul’, etc) after a specified time has elapsed. For example, if you enter
‘Change oil’ to be displayed in 30 hours, the message ‘Change oil’ will be displayed after the
GNC 250XL has been running in Normal mode for 30 hours. After appearing, the message
will be displayed each time the GNC250XL is turned on until it is changed or deleted.
To enter a scheduled message:
1. Press
N
and rotate
O
to display NAV Menu 2.
2. Press
C
twice and rotate
O
until ‘Scheduler?’ is highlighted.
3. Press
E
.
4. Rotate
O
to highlight the message you would like to edit. To delete, press
\
,
then
E
.
5. Use
K
and
O
to enter the message. Press
E
.
6. Use
K
and
O
to set the time to elapse before the message is displayed, in hours and
minutes, up to 99 hours and 59 minutes (this time is cumulative and counts whenever
the GNC 250XL is on in normal operating mode).
7. Press
E
.
You may edit another scheduled message by repeating steps 4, 5, 6 and 7, or if you
are finished, press
C
.
31
The scheduled message will appear after the timer
expires and reappear every time the GNC 250XL
is powered on until the message is changed.
The scrolling arrow prompt indicates which direc-
tion to scroll to view additional listings.
SECTION
1
NAV KEY
NAV Menu 2
Scheduler
250xl manual 2 7/17/98 1:27 PM Page 31