Filter
Top Products
6. ALARMS
6-2
Message and meanings
Note: The message screen also shows equipment trouble. See section 8.3.
6.2 Buzzer Type Selection
The buzzer sounds whenever an alarm setting is violated. You can select the type of
buzzer as follows:
1. Press the MENU/ZOOM key twice to show the main menu.
2. Select [Alarms], and press the ENT key.
3. Select [Buzzer], and press the ENT key.
4. Select buzzer type, and press the ENT key.
Short: A short beep sounds.
Long: Three long beeps sound.
Continuous: Continuous long beeps sound until a key is pressed.
5. Press the MENU/ZOOM key twice to close the menu.
6.3 How to Set an Alarm
Set alarms as below:
Note: For the Anchor alarm, press the WPT/MOB key to enter the waypoint at own
boat’s position, and set it as destination referring to paragraph 5.2.1.
1. Press the MENU/ZOOM key twice to show the main menu.
Message Meaning
XTE ALARM!
The boat is off its intended course by the range set.
TIME ALARM!
The time set has come.
SPEED ALARM!
The boat’s speed is higher than the range set.
ARRIVAL ALARM!
The boat is approaching the arrival area.
TRIP ALARM!
The boat has traveled further than the preset trip distance.
ODOMETER ALARM!
The boat has traveled the total distance set.
ANCHOR WATCH!
The boat has moved a certain distance (when it should be at rest).
NO WAAS SIGNAL! WAAS signal cannot be found.