Filter
Top Products
1. OPERATIONAL OVERVIEW
1-2
How to detach the hard cover from the unit
Put your thumbs on the front and forefingers on the catches at the sides of the cover,
and pull it toward you.
1.2 How to Turn Power On/Off
1. Press the /BRILL key to turn on the power. The unit beeps and then starts up
with the last-used display mode. Your equipment takes about 90 seconds to find
its position. The equipment shows receiver status indication at the top left-hand
corner in most display modes. The table below shows these indications and their
meanings.
Status indications
*: DOP (Dilution of Precision) is the index of position accuracy, and it is the distri-
bution pattern of satellites used in position fixing. Generally, the smaller the figure
the better the position accuracy. (HDOP: Horizontal DOP, PDOP: Position DOP)
2. To turn off the power, press and hold down the /BRILL key for three seconds.
The time remaining until the power is turned off is counted down on the display.
Indication Meaning
2D 2D GPS position fixed
3D 3D GPS position fixed
W2D 2D WAAS position fixed
W3D 3D WAAS position fixed
DOP* 2D: HDOP larger than 4
3D: PDOP larger than 6
SIM Simulation mode
- - - Not fixed
Catches