Furuno CI-35H GPS Receiver User Manual


 
AP-4
4) ANALOG SHIP SPEED Current signal for Analog Display.
-3.33mA to 10.0mA/-10kt to 30kt
(Maximum load 400 ohms)
5) TRUE BEARING DATA Clocked-serial (Furuno AD-100 format) ........................1ch
9. MISCELLANEOUS FUNCTIONS
Self-check function,
Simple demonstration function
10. NAV-AIDED TIDE MEASUREMENT
Even where ground tracking is unattainable, absolute tide movements (tide on ground) can
be calculated by applying accurate position and heading data to CI-35/35H. This function
may be extremely useful for deep sea purse seining or oceanographic survey.
Note: 1. Depths are measured below transducer surface.
2. The CI-35/35H uses an acoustic wave for speed measurements. Aeration due
to rapid accelera tion/deceleration, heavy engine/propeller vibration or
interference from other sounding equipments can degrade performance of
this equipment.
3. Tide speed measuremants are made by detecting echoes from underwater
microscopic objects like plankton. If density of microscopic objects
is too high or too low, depending on season or operating areas,
CI-35/35H may not provide normal measuring performance.
11. ENVIRONMENTAL CONDITIONS
1) Temperature: 0 to 45°C
2) Humidity: 80%RH (without condensation)
12. POWER SUPPLY
Main's input: 100/110/115/220/230VAC,50/60Hz,1ø
Power consumption: 100 - 240 VDC : 3.0 - 1.25 A
13. COATING COLOR
Display unit: Front panel; Munsell N1.5 Newtone NO.5 (not changed)
Cover plate; Munsell 2.5GY5/1.5(standard) or 2.5G7/2
Transceiver Unit: Munsell 2.5GY5/1.5(standard)or 2.5G7/2
Junction Box: Munsell 2.5G7/2 (not changed)