Filter
Top Products
3-8
FUNDAMENTAL DATA SECTION
PRESENT TIME Display
` Refer to page 4-4 to set date/time of the internal clock. (MENU 2 - “DATE/TIME”)
` It is possible to display time data received from the external navigation equipment, instead of
the internal clock. However, the time display may not increment every one second since the
time update depends on the incoming data interval. Refer to page 4-8 to use the external clock.
(Set MENU 4 - “TIME DATA” to “EXT”.)
` Date is not displayed in the standard screen, but on top line in the MENU window.
TRIP TIME/DISTANCE Display
The TRIP function is used to measure distance-run in a certain time or time-elapsed to run a certain
distance. It is also possible to cause audible and visible alarm when a certain time limit or distance
limit is reached.
To set time limit or distance limit, call ALARM menu by the
ALARM
key and enter desired values
in the “TRIP” option. (See page 4-15.)
Note that the time limit setting provides trip distance on the TRIP window, and the distance limit
setting provides trip time display. (Time and distance are interlocked.)
To start trip count, press the
TRIP
key.
The count increments as vessel moves or as
time elapses.
When time limit or distance limit is reached,
counting is stopped, the distance or time count
in the TRIP window turns red, and the audible
alarm, if enabled, sounds.
kt
AVERAGE
0
10
20
10
20
3°
0.4
SPEED
12.3
kt
NW
135
°
COURSE MODE COMPASS
GT 270.0
17 : 41 : 00
0.8
kt
1.2
kt
0.5
kt
N
0
°
SE
320
°
NE
45
°
DEP TIDE DIRECTION TRIP
0.00 NM
N
1
15
2
18
3
30
Present time
Trip time
(or Trip distance)
1 nm
Distance limit set to “1 nm”
TRIP
00 : 05 : 32
Time-elapsed
to run 1 nm
(5 min 32 sec)
TRIP
Count start