Filter
Top Products
viii
CALIBRATING COURSE OFFSET (Automatic)
A. When ground-tracking is attainable:
1. Make sure the navaid (GPS) is working correctly and accurately.
2. On CI-35/35H, select ground tracking mode. (Press the TRACKING MODE key to see the
“GT” mode indication on the display.)
3. In Menu 4, set ‘CRS CAL MODE’ to “GT”.
4. Run your boat at a speed about 10 kts, keeping the same direction. To minimize the effect of
gyro speed error, it is desirable to run along parallels (i.e., eastward or westward).
5. In Menu 4, place the cursor on “START” (‘CRS CAL EXEC’) and then press the EVENT
key. As soon as you press the EVENT, “0.0” should appear in reverse text at the upper-right
part of the display. After 2 mile-run, the display will show the course calibration angle
(result of calculation) in normal text.
Lead run
2 n.m. (approx)
Course calib. angle
calibrated to fit these
two courses made good
Course made good
by ext. navaid (GPS)
Course made good
by CI-35/35H plus Gyro
Start Point
EVENT
pressed
B. When ground-tracking is unattainable:
1. Make sure the navaid (GPS) is working correctly and accurately.
2. On CI-35/35H, select nav-aided mode. (Press the TRACKING MODE key to see the “NAV”
mode indication on the display.)
3. In Menu 4, set ‘CRS CAL MODE’ to “NAV”.
4. Run your boat at a speed about 10 kts, keeping the same direction. To minimize the effect of
gyro speed error, it is desirable to run along parallels (i.e., eastward or westward).
5. In Menu 4, place the cursor on “START” (‘CRS CAL EXEC’) and then press the EVENT
key. As soon as you press the EVENT, “0.0” should appear in reverse text at the upper-right
part of the display.
6. When the boat has run for 5 minutes, turn your heading almost 180˚ and steer back to the
start point. After 10 minute-run, the display will show the course calibration angle (result of
calculation) in normal text.
Start Point
EVENT
pressed
Lead run
5 minutes
(half way)
off the track by 5 to
10° not to get on
own wake
calibrated to equalize
these tides