CM6200 Install Guide
Starter System
www.firstechonline.com | www.compustar.com
Copyright 2009 Firstech, LLC.
Page 20
Option Group 3 Continued
Feature Default Setting - I Optional Setting - II Optional Setting - III Optional Setting - IV
3-09
Horn Output When Alarm Is
Triggered
Pulsed Output
Constant Output
(Secondary Siren)
3-10
Valet
Key 5 times, or Remote
(I+III) while Ignition
is On
Key 5 times or Remote
(I+III)
Secure Valet
(Default code 3,3)
3-11
Auxiliary Settings Mode Disabled Enabled
3-12
Auxiliary Settings With Pas-
sive Arming
No Passive Arming Passive Arming
3-13
Defroster Temperature Control Standard
Only below 32 degrees
F
3-14
Defroster Output Timing 0.5 sec pulse 3 min latch 7 min latch
Constant Output Until
Remote Start Shuts
Down
3-15
Soft Disarm Off On
Option Group 4
Feature Default Setting - I Optional Setting - II Optional Setting - III Optional Setting - IV
4-01
Aux 1 output 0.5sec Latch 20 sec Program
4-02
Aux 2 output 0.5sec Latch 60 sec Program
4-03
Aux 1 output Control By Remote Arm Disarm
Negative (-) out w/ign
shutdown
4-04
Aux 2 output Control By Remote Arm Disarm Panic
4-05
Secure Aux Output
(1 and 2 Only)
On Off
4-08
Extended Accessory After Ign
Shutoff
Off 10 sec 30 sec
Until Door Open (1
min max)
4-09
Key Sense or Glow Plug input Glow Plug Input Key Sense Input
4-10
Trigger Start or Closed Loop
Alarm Trigger Input
Trigger Start input
Closed Loop System
Input
4-11
Bypass Through RS232 Port ADS Fortin
4-13
Antenna Power Save Off 1 Day Later 2 Days Later 3 Days Later
4-14
Low Battery Warning Off On