Filter
Top Products
26
©
2002
Directed Electronics, Inc.
Menu #3 - Remote Start Features
Feature Descriptions
The features of the system are described below. Features that have additional settings that can be
selected only when programming with the 998T Bitwriter are indicated by the following
icon:
Menu #1 - Basic Features
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when
the transmitter is used. When set to passive, the system will arm automatically 30 seconds after the
last door is closed. To alert the consumer of passive arming, the siren will chirp 20 seconds after the
door is closed. This provides the consumer with an audible warning prior to the system actually
arming. At the 30 second mark, the system will arm, but the siren will not chirp.
1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of
the system.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors
will lock three seconds after the ignition is turned on and unlock when the ignition is
turned off. The 998T Bitwriter™ will display separate steps for ignition lock and ignition
unlock. They can be programmed on or off independently.
1-4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1-1, then the system can
be programmed to either lock the doors when passive arming occurs, or only lock the doors when
the system is armed via the transmitter/receiver. Active locking means the system will not lock the
doors when it passively arms. Passive locking means that the system will lock the doors when it
passively arms.
Feature One Chirp Two-Chirp
Number Setting Setting
3-1 Engine checking ON Engine checking OFF
3-2 Engine checking TACH Engine checking VOLTAGE
3-3 Run time: 12 minutes Run time: 24 or 60 minutes
3-4 Parking lights flashing Parking lights constant
3-5 Crank time 0.6 seconds 0.8, 1.0, 1.2, 1.4, 1.6, 1.8, 2.0, 4.0
3-6 Voltage check - high Voltage check - low
3-7 Auxiliary output - factory disarm Special accessory
3-8 Status output Factory re-arm output
3-9 Anti-grind ON Anti-grind OFF