©
2003
Directed Electronics, Inc.
23
System Features Learn Routine
The System Features Learn Routine dictates how the unit operates. Due to the number of steps,
they have been broken up into three menus. It is possible to access and change any of the feature
settings using the Valet/Program switch. However, this process can be greatly simplified by using the
998T Bitwriter. Any of the settings can be changed and then assigned to a particular transmitter, up
to four, a feature called Owner Recognition. Each time that particular transmitter is used to disarm
the system, the assigned feature settings will be recalled. Owner Recognition is only possible when
programming the unit via the 998T Bitwriter.
If the system was previously programmed using the 998T Bitwriter, the learn routine may be
locked. If the siren generates one long chirp when attempting to program the unit, the learn routine
is locked and must be unlocked using the 998T Bitwriter.
1.
OOppeenn aa ddoooorr..
(The H1/5 GREEN wire or the H1/7 VIOLET wire must be
connected.)
2.
IIggnniittiioonn..
Turn the ignition on, then back off: (The heavy gauge PINK wire of
the relay satellite must be connected.)
3.
SSeelleecctt aa MMeennuu..
Press and HOLD the Valet/Program switch. (The
Valet/Program switch must be plugged into the BLUE port.) After three
seconds the siren will chirp once indicating entry to the Basic Features Menu.
If this is the menu you wish to access, release the button and go on to Step 4.
If the button is not released, you will jump to the next menu and the siren will
chirp twice. There are three possible menus. Once you have selected the desired
menu, release the Valet/Program switch.
4.
SSeelleecctt aa FFeeaattuurree..
Press and release the Valet/Program switch the number of
times corresponding to the feature you wish to change. For example, to access
the third feature, press and release the switch three times. Then press the switch
once more and HOLD it. The siren will chirp the number of times equal to
the feature you have accessed.