Filter
Top Products
24
©
2002
Directed Electronics, Inc.
5.
PPrrooggrraamm tthhee FFeeaattuurree..
While HOLDING the Valet/Program switch, you can
toggle the feature on and off using the transmitter/receiver. Pressing the lock
button will select the one chirp setting. Pressing the unlock button will select
the two chirp setting. (See System Features Menus section of this guide.)
NOTE: Some features have more than two settings. Pressing the lock button
selects the one-chirp setting; pressing the unlock button will cycle through all
possible two-chirp settings.
6.
RReelleeaassee tthhee VVaalleett//PPrrooggrraamm SSwwiittcchh..
Once a feature is programmed:
➤➤
Other features can be programmed within the same menu.
➤➤
Another menu can be selected.
➤➤
The learn routine can be exited if programming is complete.
To access another feature in the same menu:
1. Press and release the Valet/Program switch the number of times necessary to advance from the
feature you just programmed to the next one you want to program.
2. Then press the Valet/Program switch once more and HOLD it.
For example, if you just programmed the third feature in the menu and you would like to program
the seventh feature in the menu, you would press and release the Valet/Program switch four times
and then press it once more and HOLD it. The siren would chirp seven times to confirm access to
the seventh feature.
To select another menu:
1. Press and HOLD the Valet/Program switch.
2. After three seconds, the unit will advance to the next menu and the siren will chirp, indicating
which menu has been accessed.
For instance, if you just programmed some features in Menu #1 (Basic Features) and you wish to
program a feature in Menu #2, you press and HOLD the Valet/Program button. After three
seconds, the siren chirps twice indicating access to Menu #2.
To exit the learn routine do one of the following:
➤➤
Close the open door.
➤➤
Turn the ignition on.