Directed Electronics RSIII Automobile Parts User Manual


 
16
©
2002
Directed Electronics, Inc.
Remote Start Harness Wire Descriptions
H3/1 BLUE Status Output
This wire supplies a 200mA output as soon as the module begins the remote start process and is
normally used to activate an immobilizer bypass module. The H3/1 BLUE wire can also be
programmed to rearm a factory anti-theft system when the remote start shuts down. (See the Feature
Descriptions section in this guide.)
NOTE: This wire can also be used to bypass optional sensors and door triggers as described in the
following diagram.
To bypass an optional sensor:
H3/2 BLUE/BLACK (-) Optional Third Ignition Output
This output provides 200mA as soon as the remote starter is activated. It can be used to power a
relay to energize a positive (+) third ignition as shown below. This output is capable of driving two
relays if necessary.
SENSOR TRIGGER OUTPUT
SENSOR INPUT OF SYSTEM
(+) 12V FUSED
CUT
85
86
30
87
87A
DIA-141
H3/1 BLUE STATUS
OUTPUT