Filter
Top Products
45
3) Brake pads must be checked periodically for wear. They are also available
from a Cobra dealer. The brake pad must be a minimum thickness of 2.5mm.
This is measuring the pad + the holder as shown below.
Figure 35
Brake bleeding procedure:
1) Remove brake caliper using 4mm Allen wrench as shown in pad removal
procedure. Pry pads outward to fully retracted position.
2) Remove reservoir cap using a Torx T25 wrench as shown. Keep reservoir
level.
Figure 36
3. Remove bleed screw on caliper using a 3mm Allen wrench as shown.