Filter
Top Products
35
Figure 24
14. Reinstall new bearings, seal and impeller. Clean all threads and use green
(wicking / bearing retainer) thread locker.
15. Using a liberal amount of grease on the outside seal, bearings and inside of
case, reinstall bearing assembly by using a 0.500” ID by 1.000” OD steel tube 2”
long and tap on end of tube per figure 25.
Figure 25
16. Re-
assemble in same order of disassembly. Clean all threads and use green
(wicking / bearing retainer) thread locker on the belt retainer screw.