Filter
Top Products
within 10 seconds, press the momentary side six times to jump to row 6. After a
brief pause, you’ll hear 1 chirp to confirm that sound 6 is now off.
4. Now look up the location on the table of QuietChirps. Note that it’s in column 3,
row 5 (latched, center, latched, center, latched, center, wait for the 3-chirp/column
3 confirmation, then 5 momentary presses). After a brief pause, you’ll hear two
chirps to confirm that the QuietChirps feature is now on.
5. To exit the program mode, turn the ignition off. You’ll hear 3 chirps to confirm
program mode exit.
You just made three programming changes in only five steps. Easy, isn’t it? Notice
again that in step 3 on the previous page you did not have to re-select column 1. If you
don’t touch the switch, the system stays in the column for 10 seconds to allow you to
select any other feature(s) in the same column without having to re-enter the column
number. Of course, you can select a new column at any time.
If you wait more than 10 seconds, the system automatically jumps back to the “Feature
Select” position. This is the “stand-by” position: ready for entry of a new programming
selection. If no action is taken for the next 60 seconds, the system automatically exits
program mode, perfect if you make a few programming changes while driving.
Reset all features
Whenever you wish, you may reset all the user-selectable features to their factory
settings (factory settings are noted in bold type on the Table of User-Selectable
Features). Doing so will reset all user-selectable features except your current valet code,
nor will it erase the remote controls programmed into your system (to do this, use the
column 2, row 6 Erase all remotes feature).
To reset all other user-selectable features, use the following procedure:
1. Turn on the ignition, or start the engine (skip this step if the engine is running).
2. Enter your valet code (see pages 18-19), then press and continue holding the
PlainView switch to its momentary side for about 10 seconds. You will first hear a
chirp (after about 3 seconds) to indicate that the system is in program mode.
Continue holding to the momentary side. After about 10 seconds you will hear 4
rapid chirps, indicating that all user-selectable features except the valet code and
remotes have been reset to their factory settings.
37