Filter
Top Products
To drive the vehicle
1. Disarm and unlock the doors by pressing button 1 on the remote control. The parking
lights will blink off once and the interior lights will turn on.
2. Enter the vehicle and close the door, but do not press the brake pedal nor move the
transmission out of park.
3. Insert your key and turn the ignition switch to its “ON” position (don’t worry if you
turn the switch all the way to the “START” position; the system’s StarterGuard
feature will prevent you from accidentally grinding the starter motor while the engine
is running under the IntelliPage’s control). The interior lights will turn off and, if it is
dark, the headlights will turn on.
4. Press the brake pedal. The system is now disengaged and your vehicle will operate as
usual.
NOTE: As an anti-theft measure, if someone presses the brake pedal or moves
the transmission out of park BEFORE turning the ignition switch to the “ON”
position, the IntelliPage will immediately shut down the engine.
The AutoStart features
Your Smart Remote Starter III has two AutoStart features:
n
AutoStart Battery Mode:
This is an especially valuable feature when you need to
leave your vehicle parked for an extended period of time. If engaged, the system
will continually monitor the voltage level of the vehicle battery while you are
away. If the voltage drops below a preset level, the system will automatically start
the engine and recharge the battery (to conserve battery power, the IntelliPage
will not activate the parking lights nor any preset accessories in this mode).
Likewise, the system automatically shuts down the engine once the battery is
properly charged or after 30 minutes, whichever occurs first. If needed, the
process will repeat every eight hours until the battery is properly charged.
AutoStart Battery Mode is automatically canceled as soon as you drive your car.
n AutoStart Temperature Mode: You may set IntelliPage to AutoStart the vehicle if
the temperature drops below 15°F (-9°C). The engine will idle for 30 minutes or
until you enter and drive the vehicle, whichever occurs first. AutoStart
Temperature Mode is automatically canceled as soon as you drive your car.
n AutoStart Dual Mode: This mode selection instructs the system to monitor both the
battery voltage and temperature. Thus either condition will trigger AutoStarting.
AutoStart is a two step process. You first select the AutoStart mode you want the system
to use. You will later (this can be moments or months later) use your remote control to
command the system to use the AutoStart mode you previously selected:
1. Use the programming procedure noted on pages 35-39 (column 4, row 4) to select
either AutoStart Battery Mode, AutoStart Temperature Mode or AutoStart Dual-Mode.
2. Disarm the system with button 1, then transmit channel 10 (LevelShift twice, then
button 2). The parking lights will flash twice to acknowledge that the system is now
in the AutoStart mode you selected in step 1.
3. Press button 1 to arm the system. Your IntelliPage will remain in AutoStart mode
until you next drive the vehicle.
28