Filter
Top Products
For the Bose
®
amplified radio, perform the
following steps to setup the equalization settings:
1. Press the Tune knob until the DSP (Digital
Signal Processing) label displays.
2. Press the pushbutton located under the DSP
label to get choices of Norm, Driv, Rear, and
Surround, to display.
3. Press the pushbutton located under the
desired setting.
To select Surround, press either the fourth or
fifth pushbutton located under the displayed
Surround until Centerpoint displays.
To return to the manual mode, press the tune
knob. Select either BASS, MID, or TREB and start
to manually adjust the settings by turning the
tune knob.
Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade): To adjust balance
or fade, press the tune knob until the speaker
control labels display. Continue pressing to
highlight the desired label, or press the pushbutton
positioned under the desired label. Turn the
tune knob clockwise or counterclockwise to adjust
the highlighted setting. The highlighted setting
can be adjusted by pressing either the SEEK,
FWD (forward) or REV (reverse) buttons until the
desired levels are obtained.
To quickly adjust balance or fade to the middle
position, press the pushbutton positioned under the
BAL or FADE label for more than two seconds.
A beep sounds and the level adjusts to the
middle position.
To quickly adjust all speaker and tone controls to
the middle position, press the tune knob for
more than two seconds until a beep sounds.
271