Filter
Top Products
26
Specifications and designs are subject to change without
any notice or obligation on the part of the manufacturer.
FCC Compliance Statement
is device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) is device may not cause harmful interference, and
(2) is device must accept any interference received, including interference that may cause undesired
operation.
NOTE: is equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. ese limits are designed to provide reasonable protection against
harmful interference in a residential installation.is equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
Note: e ONIX complies with Part 15 of the FCC interference limits for Class B digital devices FOR HOME
OR OFFICE USE. ese limits are designed to provide reasonable protection against harmful interference in a
residential installation, and are more stringent than “outdoor” requirements.
e ONIX does not contain any user-serviceable parts. Repairs should only be made by an Authorized
Bushnell repair center. Unauthorized repairs or modifications could result in permanent damage to
the equipment, and will void your warranty and your authority to operate this device under Part 15
regulations.
e shielded interface cable which is provided must be used with the equipment in order to comply
with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.