Filter
Top Products
bühler
2500 Bale Carrier
19
4. Chains
Check for proper chain tension and sprocket
alignment after first use and every 50 hours
thereafter.
Turn the front sprocket adjusting bolt
clockwise until there is approximately 6” (15
cm) of upward slack in the chain at the center
of the track. Clockwise increases tension and
counter clockwise reduces tension.
Proper chain tension may be verified by
raising the chain by hand.
See lubrication section for further
maintenance instructions.
FRONT ADJUSTING
BOLT
5. Wheels / Tires
Inspect hub bolts after first use and 50 hrs thereafter. Hub bolts must be torqued
to 125 ft-lb (170 Nm).
Thread-locking compound such as Locktite 242 is recommended for the hub
bolts.
Ensure that dust caps are firmly in place.
Check tire pressure regularly: 90 psi (620 kpa).
The wheel bearings should be inspected and re-packed annually with a SAE
multi purpose type grease. If hub is supplied with grease fitting, grease every
500hrs.
Air valve should face away from the hub.