Buhler 2500 Automobile Accessories User Manual


 
bühler
2500 Bale Carrier
15
7. Unloading
DANGER
Make sure area is clear before unloading. Failure to do so
could result in serious injury or death.
NOTE:
Left or right decks can be unloaded individually or together. However, the
pusher moves faster and has more torque when operated individually. Do not run
pushers all the way to the end, the resulting shock load may cause damage to chain
and drive.
Extend tilt cylinder to raise carrier beams by engaging the tractor’s extension
hydraulics.
Depress and hold LH and/or RH PUSHER BACK switch to push the bales off the
carrier beam.
Once the rear bale has been pushed off the carrier, slowly drive forward while
pushing the bales back (unloading) to keep all bale ends in contact.
When amber reflector on inside of the carrier
beam becomes visible stop the pusher. The
reflector is approximately 26” (66cm) from the
end of the beam.
Slowly drive forward to unload the last bale.
Retract the tilt cylinder to lower the beam and
begin the next loading cycle.
Return PUSHER to the front of the 2500
Bale Carrier to prepare for the next cycle.
AMBER REFLECTOR
LOCATION