Filter
Top Products
AW Company 8809 Industrial Drive, Franksville, WI 53126 à web: www.awcompany.com
Tel: 262-884-9800 Fax: 262-884-9810 | Email: aw@awcompany.com
REV. 4 10/05 EMO-500 Manual.DOC
9
The Quick Program Options
While many programming variables such as KFR or meter selection may only require a
"one time" setting - others may require some experimentation to find maximum efficiency
settings. It may also prove desirable to allow an operator in the field some limited ability
to make some quick adjustments. To accommodate these circumstances a method of
jumping directly into some limited programming functions has been made available. This
method is called "Quick Programming" The functions available are noted in red on the
top line of keys -F1-F6 Function Keys & 0-1 keys.
F1 ..........................................................................................................................Ideal Ratio
F2 .......................................................................................................................... Gate Time
F3 ............................................................................................................... Ratio Warning %
F4 ................................................................................................................... Ratio Alarm %
F5 .................................................................................................................... Decimal Point
F6 ...................................................................................................................................Enter
0 ......................................................................................................................... Sample Size
1 ...................................................................................................................Specific Gravity
Connect the Scroll Line Input (Pin 2) and the Common 1 - 5 (Pin 6) of the 15 Pin
connector on the back panel of the EMO 500 -a momentary contact switch is
recommended. While this connection is made, simultaneously push any one of the keys
shown above. NOTE: This will not work if full programming is enabled.
*NOTE See Appendix D for a circuit drawing.
To activate a Quick Programming Option.