Filter
Top Products
AW Company 8809 Industrial Drive, Franksville, WI 53126 à web: www.awcompany.com
Tel: 262-884-9800 Fax: 262-884-9810 | Email: aw@awcompany.com
REV. 4 10/05 EMO-500 Manual.DOC
11
Programming the EMO 500
As a security precaution, access to the full programming section is only possible when pin
5 is "enabled". This can be accomplished by connecting pin 5, on the 15 pin connector, to
the pin 6 Common (See Appendix D). Next, after first hitting F2, each function key, F1
through F6, will then allow access to the programming menu indicated immediately
above it on the red banner strip (The banner strip is labeled 'PROGRAMMING' as
indicated below).
ESCAPE
ACCESS
RATIO
LIMITS
METERS
GLOBALS
PROGRAMMING
Reminder Note: The other programming functions, indicated in red, on the F1 - F6 and 0
- 1 keys are activated by the Quick Programming Options which are reviewed on page 8.
(Quick Programming is provided for immediate access to a few limited programming
functions only).
AFTER JUMPERING PIN 5 TO PIN 6 - THE ACCESS SEQUENCE IS AS FOLLOWS:
MAIN MENU
F2
OPTIONS
F3 F4 F5 F6
RATIO PRG. LIMIT PRG. METER/UNIT PRG. GLOBALS
PRG.
Enable Prog. --> F2
-->
-->
-->
-->
F3
F4
F5
F6
...
...
...
...
(Access to Ratio Prog)
(Access to Limit Prog)
(Access to Meter/Units)
(Access to Global Prog)
IMPORTANT ACCESS IS DENIED TO F3, F4 & F5 UNTIL F2 IS PRESSED FIRST.
THIS IS A SECURITY MEASURE TO PREVENT UNINTENTIONAL PROGRAMMING
CHANGES