3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 8
Finish unfastening the solid brake line and pull it clear of the bracket.
Quickly snap one of the supplied black
rubber caps over the end of the hard
line. This should control brake fluid loss
for the duration of the installation.
Step 2 (continued)Step 2 (continued)
Step 2 (continued)Step 2 (continued)
Step 2 (continued)
Use a screwdriver or pliers to remove the
metal spring clip holding the stock brake
line to the chassis bracket.
Retain the clip. It will be used with
the new brake line.
Be careful of any fluid which may drip
from the end of the line.
Using a 12mm wrench or socket, remove
the bolt holding the line positioning
bracket to the vehicle.
