Step 5Step 5
Step 5Step 5
Step 5
Install Caliper BracketInstall Caliper Bracket
Install Caliper BracketInstall Caliper Bracket
Install Caliper Bracket
Install the caliper adapter bracket to the spindle
using the stock caliper bolts. The pre-installed
studs face rearward, and the bracket mounts on
the outboard side of the mounting lugs, as
shown.
Torque caliper bracket bolts to
80-85 lb-ft80-85 lb-ft
80-85 lb-ft80-85 lb-ft
80-85 lb-ft.
Step 6Step 6
Step 6Step 6
Step 6
II
II
I
nstall Anstall A
nstall Anstall A
nstall A
erer
erer
er
oRoR
oRoR
oR
otor Aotor A
otor Aotor A
otor A
ssemblyssembly
ssemblyssembly
ssembly
Rotors
MUST MUST
MUST MUST
MUST be cleaned with soap and water prior to installation. Not doing so
will damage the rotors and pads and prevent the brakes from performing properly.
Even though it may not look like anything is washing off, the rust inhibitor is in
place and must be removed. Not cleaning the rotors will severely impact the perfor-
mance of your new brake system.
Scrubbing AeroRotor with ScotchBrite pad,
soap and water.
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 11
Do not skip this step!
Apply a few drops of 262 Loctite to the
last few threads of each caliper bolt.
