Step 7Step 7
Step 7Step 7
Step 7
Install Caliper and PadsInstall Caliper and Pads
Install Caliper and PadsInstall Caliper and Pads
Install Caliper and Pads
- Determine the left and right side calipers. The calipers are marked on each box. As a
check, the bleed screws always go to the top of the caliper.
Remove the 2 bolts holding the caliper bridge using a 5mm Allen wrench.
Remove the caliper bridge taking note of the direction it is installed in and the correct location of
the pad retaining wire clip, which typically, but not always, stays attached to the bridge.
In order to stiffen the caliper, the
bridge is a snug fit and the bolts
may be tight when removing. Keep
turning bolts gently with pressure
applied in the direction of removal.
After removing the bolts, it may be
necessary to tap the bridge out from
the inside of the caliper with a plas-
tic or leather hammer or similar
tool. The handle of a tool works well
for this. With use, the bridge and
bolt will become easier to remove
and install.
Bridge Bolts
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 16
