PREVENTIVE MAINTENANCE REAR AXLE AND SUSPENSION
Regional Haul
(R05/10) Y53-6033 – 247 –
• No initial drain is required on Eaton axles that are fac-
tory filled with an Eaton-approved synthetic lubricant.
• Petroleum-based lubricants must be drained within
the first 5,000 miles (8000 km) if converting to an
approved synthetic lubricant.
See Table 1, “Recommended Maintenance Intervals,”
Page 150 for standard rear axle service intervals.
• Use petroleum-based lubricants meeting MIL–L–
2105–C/D grade specifications or approved synthetic
lubrication. Do not use oil additives.
To change axle lubricant:
1. Park the vehicle on level ground with the axle lubri-
cant at normal operating temperature.
2. Remove filler (1) and drain plug (2).
3. Completely drain the oil and clean the drain plug.
CAUTION: Do not overfill axles.
4.Reinstall the drain plug (2) and refill with recom-
mended oil up to the bottom of filler plug hole.
5. Reinstall filler plug (1).
Table 11 Drive Axle Lubrication
MODEL RECOMMENDED LUBRICANTS
AMBIENT TEMPERATURE RANGE
VISCOSITY (SAE)
° C ° F
EATON,
ROCKWELL
EP gear oil, MIL-L-2105D, API GL-5.
-26 to +38 -15 to +100 80W-90
Synthetic Lubricant: Chevron RPM
Synthetic Gear Lubricant, or equal, meeting
MIL-L-2105D and Eaton PS-037 specifica-
tion.
-40 to +38 -40 to +100 75W-90
