A SERVICE OF

logo

Open as PDF
next previous
EN Internal assemblies 79
Exit Roller Assembly
1 Remove Printer Covers.
2 Grasp both tabs at the lower ends of the Exit Roller bushings and pull inward. This will release
the tabs from the printer chassis (Figure 6-8, callout 1).
3 Rotate the tabs 90 degrees, clear of the printer chassis (Figure 6-8, callout 2).
4 Lift the roller out.
Figure 6-8 Exit Roller removal
To reinstall
The end of the Exit Roller that has a gear attached must fit into the gear train. Although it is possible
to reinstall the Exit Roller so that the gear end is on the opposite side of the printer, this placement
would cause paper path problems.
1
2
Service.book Page 79 Thursday, September 14, 2000 11:15 AM