32 Site requirements EN
Site requirements
Operating environment
The environmental requirements listed in the table below must be maintained to ensure the proper
operation of this printer.
Consider the following points before installing the printer:
l Install in a well-ventilated, dust-free area.
l Install on a hard, flat and continuous surface, with all four printer feet level. Do not install on
carpet or other soft surfaces.
l Ensure adequate power is supplied. Printer power requirements are listed under
“Specifications” in Chapter 1. Uninterruptible power supplies (UPS) should not be used with this
printer.
l Install away from direct sunlight, open flames, or ammonia fumes. If the printer is placed near
a window, make sure the window has a curtain or blind to block any direct sunlight.
l Install with enough space around the printer for proper access and ventilation.
(See Figure 2-1.)
l Install printer away from the direct flow of exhaust from air ventilation systems.
Table 2-1 Environmental requirements
LaserJet 5L/6L/6L Pro & Cartridge Operating Storage
Temperature 50 to 90.5° F (10 to 32.5° C) 32 to 104° F (0 to 40° C)
Humidity 20 to 80% RH
(with no condensation)
10 to 80% RH
(with no condensation)
Service.book Page 32 Thursday, September 14, 2000 11:15 AM
