90 Removal and replacement EN
Paper Exit Sensor Flag
1 Remove the Printer Covers, Delivery Assembly (Figures 6-9 and 6-10), and Fuser Pressure
Plate (Figure 6-11).
CAUTION Before proceeding to Step 2, examine the Paper Exit Sensor flag. It is important to note the position
of the spring mechanism on the flag. The spring must be reinstalled to exactly this position.
2 Remove the Paper Exit Sensor flag by pressing down on the left side and pulling up on the right
side.
To reinstall
Note It is important that you reinstall the flag correctly, because installing it incorrectly will cause the Control
Panel to display an error with the Paper Exit Sensor (PS201).
Place the left side of the flag in the correct position first, then slide the right side into place, making
certain the spring is on top of the flag (Figure 6-19). If the spring exerts no pressure on the flag, it
may require “re-springing” by giving the spring an extra turn before reinstalling. The flag should fit
snugly in place.
Figure 6-19 Paper Exit Sensor Flag replacement
Service.book Page 90 Thursday, September 14, 2000 11:15 AM
