EPSON Stylus Color 900 Revision C
Adjustment Adjustments 147
32. The following screen appears.
Figure 5-30. Head Angular Adjustment End Sequence
33. The printer turns off in an instant. This sequence, called Hardware
Reset, takes approximately 30 seconds to execute. During this
sequence, the programs shows countdown and the message
indicating restriction on any action using the program and
generating commands.
NOTE:
The Hardware Reset performed here, which initializes the carriage
location management, is considered very important, because there
is a possibility that the print position changes slightly during the
adjustment.
34. The screen returns to Head Angular Adjustment Initial screen
(Figure 5-14) and the next adjustment can be selected.
Enter: OK
Resetting hardware now.
30
>** Don't use any com m ands until the CR's m otion is com pleted. **<
