EPSON Stylus Color 900 Revision C
Adjustment Adjustments 145
16. The following screen appears.
Figure 5-25. Prompt to Move the Angular Adjustment Lever
17-1. At first, set the angular lever to the center position. (As the
center value is marked with the protrusion, it can be easily
found.)
17-2. Push the color I/C from the front side to eliminate tolerance by
using a fine driver of tweezers.
17-3. Gently tighten the right side screw at first, then gently tighten the
left side screw.
Figure 5-26. Setup for the Head Angular Adjustment Lever
NOTE:
During the step 12 onward, the printhead is left away from the
capping position. Therefore, please make this adjustment as fast as
possible to prevent the printhead surface from drying. Otherwise,
you will spend extra time on solving the print problem as a result.
18. Press the Enter key in the screen (Figure 5-25).
19. The printer runs the Head Angular Adjustment Pattern. The
following screen appears.
Figure 5-27. Prompt to Move the Angular Adjustment Lever
20. Select “Re-Adjustment” in the screen (Figure 5-27).
1. After you have moved the angular adjustment lever,
2. push the color I/C from front side by using fine driver or tweezers.
3. Please gently tighten the screws the right side at first, and press
th e E n te r k e y.
4. The head angular adjustm ent pattern will be printed.
E n te r: O K
In ca se o f 1 st p rin t:
Angular Lever C enter position
Re-Adjustm ent
End
E s c : U p /D o w n a rro w s : S e le c t E n te r: O K
Do not eject a paper until you've printed out 5 patterns.
And select out the best pattern and lever state.
