Filter
Top Products
8-51
5B410023
Fuse replacement
The main fuse, the fuel injection system fuse,
and the fuse box are located under the hood.
(See pages 8-7–8-8 for hood opening and
closing procedures.)
If a fuse is blown, turn off the main switch and
install a new fuse of the specified amperage.
If a fuse is blown, replace it as follows.
1. Remove the quick fastener screws.
2. Remove the battery compartment cover
by lifting it up and pulling it out.
1. Quick fastener screw (× 2)
2. Battery compartment cover
Turn the key to “OFF” and turn off the electri-
cal circuit in question.
NOTICE
To prevent accidental short-circuiting,
turn off the main switch when checking or
replacing a fuse.
3. Remove the blown fuse, and then install
a new fuse of the specified amperage.
WARNING! Always use a fuse of the
specified amperage. Never use any
material in place of the proper fuse.
Using an improper fuse can cause
damage to the electrical system and
may lead to a fire.
1
2
EE.book Page 51 Thursday, September 6, 2007 4:28 PM