8-33
5B410018
Cleaning the spark arrester
WARNING
Hot exhaust system may cause burns. To
avoid burns or fires, make sure that the en-
gine is stopped and the exhaust system is
cool before cleaning spark arrester. Do not
start the engine while cleaning the exhaust
system.
1. Remove the bolts.
1. Bolt (× 3)
2. Remove the tailpipe by pulling it out of
the muffler, and then remove the gasket.
3. Tap the tailpipe lightly, and then use a
wire brush to remove any carbon depos-
its from the spark arrester portion of the
tailpipe and inside of the tailpipe housing.
1. Tailpipe 2. Spark arrester 3. Gasket
4. Install the gasket, and then insert the
tailpipe into the muffler and align the bolt
holes.
5. Install the bolts and tighten them to the
specified torque.
1
3
1
2
EE.book Page 33 Thursday, September 6, 2007 4:28 PM