Filter
Top Products
8-9
5B410011
Console
To remove
1. Remove the seats. (See pages 4-16–
4-17 for seat removal and installation
procedures.)
2. Remove the parking brake lever boot.
3. Pull the console forward and upward (the
drive select lever boot will come loose).
To ease removal of the console, shift the
drive select lever into the low gear “L” po-
sition.
1. Console
To install
1. Place the console in its original position.
2. Install the parking brake lever boot.
3. Install the seats.
NOTICE
● Be sure to position the seat belt buckles
to the outside of the console.
● When installing the console, be sure not
to pinch the cables or wires.
● Make sure that the groove at the bottom
of the parking brake lever boot and the
drive select lever boot fits securely
around the edge of the hole in the con-
sole.
1
EE.book Page 9 Thursday, September 6, 2007 4:28 PM