Filter
Top Products
ENGINE
3-10
• Do not screw the dipstick “1” in when check-
ing the oil level.
ECA13360
• Engine oil also lubricates the clutch and
the wrong oil types or additives could
cause clutch slippage. Therefore, do not
add any chemical additives or use engine
oils with a grade of CD “a” or higher and
do not use oils labeled “ENERGY CON-
SERVING II” “b”.
• Do not allow foreign material to enter the
crankcase.
4. Start the engine, warm it up for several
minutes, and then turn it off.
5. Check the engine oil level again.
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
EAS20800
CHANGING THE ENGINE OIL
1. Place the vehicle on a level surface.
2. Start the engine, warm it up for several
minutes, and then turn it off.
3. Place a container under the engine oil drain
bolt.
4. Remove:
• Dipstick “1”
• Oil filter element drain bolt “2”
5. Remove:
• Engine oil drain bolt “1”
(along with the gasket)
Type
YAMALUBE 4 (10W-40) or SAE
10W-40, YAMALUBE 4 (20W-
50) or SAE 20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA