Filter
Top Products
07 Wheels and tyres
160
Emergency puncture repair
07
Inflating tyres
Set up the warning triangle if a tyre must be
inflated in an area close to traffic.
– Ensure that the orange switch (2) is in
position 0 and take out the lead (5) and air
hose (4) from the side compartment (3).
– Screw the air hose’s valve connection to
the bottom of the thread on the tyre’s air
valve.
– Connect the lead (5) to one of the car’s
12 V sockets.
– Start the engine. The car must be in a well-
ventilated place.
– Start the compressor by flicking the
switch (2) to position I.
– Pump up the tyre to the pressure specified
on the tyre pressure label.
– Turn off the compressor, the switch (2)
should be in position 0. Detach the air
hose and unplug the lead. Replace the
valve’s dust cap.
– Put the lead (5) and air hose (4) into the
side compartment (3).
– Put the puncture repair kit back.
– The compressor should not run for more
than ten minutes at a time. Let it cool
afterwards as there is a risk of overheat-
ing.
– Objects with a volume up to 50 litres can
be inflated with the compressor.
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suffi-
cient ventilation.