Filter
Top Products
06 Starting and driving
140
Jump starting
06
Starting with a donor battery
If the battery in the car has become flat, you
can "borrow" electric current from either a
separate battery or the battery in another car.
Always make sure the crocodile clips on the
jump leads are attached securely to eliminate
sparks during the start attempt.
When jump starting the car, the following
steps are recommended to avoid risk of
explosion:
– Turn the ignition key to position 0.
– Ensure that the donor battery is 12 volt.
– If the donor battery is in another car,
switch off the engine in the other car and
ensure that the cars do not touch one
another.
– Connect the red jump lead between the
positive terminal on the donor battery (1+)
and the one on the battery of your car (2+).
– Connect one of the clamps from the black
jump lead to the donor battery’s negative
terminal (3–).
– Connect the other end of the black jump
lead to the earthing point (4–) by the left-
hand strut tower.
– Start the engine of the "donor car". Let the
engine run a few minutes at a speed
slightly higher than idle (1500 rpm).
– Start the engine of the car with the flat
battery.
– Remove the jump leads, first the black and
then the red. Ensure that neither of the
black jump lead’s clips comes into contact
with the battery’s positive terminal or the
crocodile clip on the red jump lead.
G020298
IMPORTANT
Do not touch the crocodile clips during the
start procedure. This could cause sparking.
WARNING
The battery can generate oxyhydrogen gas,
which is highly explosive. One spark, which
can be generated if you connect the jump
leads incorrectly, is sufficient to make the
battery explode.
The battery contains sulphuric acid, which
can cause serious burns. If the acid comes
into contact with eyes, skin or clothing,
flush with large quantities of water.
If acid splashes into the eyes, seek medical
attention immediately.